- the uncoiler and its base 

- coil sheet guiding and adjusting equipment 

- film covered device 

- main roll forming system  roof panel roll forming machine

- post-cutting device 

- hydraulic station 

- PLC control systerm 

- support table 

Glazed tile roll forming machine |

The Technical parameters: 

- suitable raw material: Color steel sheet; Galvanized steel sheet 

- thickness of the material: 0.4m to 0.7mm 

- yield strength of material: 235Mpa Roll forming machine

- uncoiler's loading capacity: Max. Capacity: 5000Kgs. (can be increased to be 10 tons) 

- forming speed: About 15m/min 

- main motor power: 5.5Kw(Depend on final design) 

- hydraulic station power: 2.2Kw(Depend on final design) 

- controling systerm: Mitsubishi PLC & converter Steel pipe |

- Votage: 380V, 3 phase 60Hz or according to at buyer's requirment. 

- the quantity of the roller group: At lest 15 groups(depend on final design) 

- machine dimension: About 20m*1.5m*1.4m(depend on final design) 

- total weight: About 10000kgs(depend on final design) 

Material of Roll former system Carbon steel pipe|

- Roller: High grade No. 45 forged steel, plated hard chromed on the surface of rollers 

With thickness 0.05mm. 

- Active shaft material: High grade No. 45 carbon wrought steel at diameter 75mm. 

- cutting blade: Cr12 mould steel with quenched treatment. Seamless steel pipe|

Working flow 

Decoiling the sheet---guiding the sheet---covering the film---roll forming---measuring the length---cutting the panel---panels to the supporter