(1) Manual decoiler

Un-powered;       single head;

max.capacity:      5000kg;Coil inner-diameter: 508mm

(2) Roll-Forming M/C:Steps:11             Roller Material: 45# steel

Voltage:380V/50Hz.    line speed:12m/min;API steel pipe|

Rolling chromium thickness:0.05 mm

(3) Cutting Mechanism

It adopts hydraulic drive and automatic location to decide the dimention and cut the target products.

Match equipment : one set of cutting tool, one hydraulic tank ,one cutter machine.

Stop to cut , Post cut      cutting length tolerance: ±2mmERW steel pipe|

Cutting tool material: GCr12 with quenched treatment 60-62°C

(4) Hydraulic System  Forming machine | 

It is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank ,the pump drive the cutter machine to begin the cutting job.

Match equipment: a set of hydraulic tank , a set of hydraulic oil pump, two hydraulic pipes and two sets of electromagnetism valves.

Power of the oil pump: 3kw    Hydraulic oil :40#Stainless steel pipe |

(5)Computer control cabinet :

It adopts Taida PLC to control. The target piece length is adjustable and digit of it can be adjusted roof panel roll forming machine

Computed mode has two modes: automatic and manual one.Alloy steel pipe|

(6)Counter :

One counter gauges length, pulses, and decides lengthGlazed tile roll forming machine |

(7) Output table

It used to load the forming plate